Why Air Sealing Should Come Before Blown-In Fiberglass Installation

Closing accessible ceiling penetrations first helps separate conditioned rooms from the attic before

2026-09-13 00:02
6

ChatGPT Image 2026年9月15日 19_08_52 (5).png

Air sealing should normally be completed before blown-in fiberglass insulation is installed on an attic floor. Fiberglass insulation is intended to reduce heat transfer through the building assembly, but it is not a substitute for a continuous air barrier. If accessible gaps remain open, air can still move between conditioned rooms and the attic through those leakage paths.

The inspection should focus on penetrations and joints in the ceiling plane. Common locations include openings around plumbing and wiring, gaps at partition top plates, attic access frames, and penetrations created for mechanical or electrical components. Each location should be evaluated individually because the correct treatment depends on the size of the opening, the surrounding material, and applicable fire and electrical requirements.

Small joints may be suitable for an approved sealant, while larger openings may require compatible blocking material before the perimeter is sealed. Heat-producing equipment, chimneys, flues, recessed fixtures, and other regulated components require special attention. Contractors should maintain required clearances and use materials approved for the specific condition rather than applying a general-purpose product everywhere.

Completing this work before blowing begins keeps the ceiling surface visible and accessible. Once the fiberglass covers the attic floor, locating missed gaps becomes more difficult. Moving newly installed material to reach a penetration can also create thin areas that must be restored afterward.

A practical final check includes reviewing the accessible ceiling plane, confirming that treated openings are fully closed, and recording any locations that could not be reached. Photographs taken before insulation is added can support the job record. If diagnostic testing is included in the project, it should be performed and interpreted by qualified personnel using the specified procedure.

Air sealing, ventilation, and insulation perform different functions within the attic system. One should not be presented as a replacement for another. Levinson Energy recommends completing the approved air-sealing work first, then installing blown-in fiberglass insulation according to the project requirements and product-specific instructions.


Levinson Export Inquiries

  • Full Name*

  • Country / Region*

  • Email*

  • Message*